ElementRemoveAttributeByIdSync
Interface AntViewDocument
Type: Method
Parameters: String Id String AttrName
Returns: Integer
Remove the attribute identified by AttrName of the html element identified by Id.
Note that the Id is case sensitive and must match the case of the html element.
The function returns:
0 when the element is found and the value of the attribute was set,
1 if the element identified by Id was not found,
3 AttrName parameter was empty
21 function is already running (can only run one at a time)
22 function timed out
23 document not connected to WebView2 control
24 Id parameter was empty
25 Trying to run a synchronous method from within a WebView2 event
This is the synchronous alternative of the ElementRemoveAttributeById method.
As the function wraps the async bits, you cannot have the asynchronous variant running when you call this.
Beware that you cannot use a synchronous call from within an AntView event.
Introduced in AntView release 1.1.354
AntView - The MS Edge WebView2 ActiveX control Date last changed: 09/25/2024